Workbench - Logo, Navgates to home page
  • Products
  • Resources
  • Contact
  • Cart
  • User settings
  • Sign Out
  • Sing in
Sing in
  • Products
  • Resources
  • Contact
  • Cart
  • Settings
  • Sign Out
•••
➤
CUSP Power electronics and electric drives laboratory
➤
Basic power electronics
  • Topic 1: Safety considerations when working in power electronics
  • Topic 2: Instructions on using DSO
  • Topic 3: Basic electric drives
  • Topic 4: Basic power electronics
  • Topic 5: Advanced electric drives

Basic power electronics

  • September 12, 2022
  • Workbench v1.7

This section contains the required components and the user-manual for the basic power electronics laboratory.

The components needed for this laboratory are listed below:

  • 01
    Workbench software
    ▶
  • 02
    Power electronics lab kit
    ▶
  • 03
    Isolated DC power supply (External link)
    ▶
  • 04
    Digital multimeter (External link)
    ▶
  • 05
    Digital signal oscilloscope (External link)
    ▶

Review, Safety considerations when working in power electronics, before proceeding with the experiments.

List of experiments:

  • 01
    Introduction
    ▶
  • 02
    Switching characteristic of Si MOSFET/GaN FET and diode
    ▶
  • 03
    Buck converter - Continuous conduction mode (CCM)
    ▶
  • 04
    Buck converter - Discontinuous conduction mode (DCM)
    ▶
  • 05
    Boost converter - Continuous conduction mode (CCM)
    ▶
  • 06
    Boost converter - Discontinuous conduction mode (DCM)
    ▶
  • 07
    Buck-boost converter - Continuous conduction mode (CCM)
    ▶
  • 08
    Buck-boost converter - Discontinuous conduction mode (DCM)
    ▶
  • 09
    Voltage mode control
    ▶
  • 10
    Flyback converter
    ▶
  • 11
    Flyback converter snubber design
    ▶
  • 12
    Forward converter
    ▶
  • 13
    Full-bridge converter
    ▶



< Basic electric drives : previous topic
next topic : Advanced electric drives >
Copyright © 2021 Sciamble Corp. All rights reserved.